September24 , 2022

How often to wash your fish concrete tanks

Related

Share

How often to wash your fish concrete tanks

While fish are still in the concrete pond, it is not advisable to drain the water completely in an attempt to change their water. It is good to reduce the water in the pond to a level and then top it with fresh water. So, washing the pond may not be necessary in the course of raising the fish.

-Advertisement-

It is advisable to be done after cropping that is after harvesting your fishes. However, if in the course of raising the fish, the pond becomes extremely slippery, then you can wash the pond with clean water and this is better done alongside with sorting of the fishes so that the fishes are not in the pond while washing the pond.

-Advertisement-

Read also: How to calculate fish stocking density

Concrete fish tanks (because of their labor and materials costs) usually cost as much or more than solid fiberglass tanks do. However, if you have free gravel and labor, they can be really cheap. If you don’t, they can often be more expensive than solid fiberglass tanks.

Think twice before using concrete structures; they will still be here 1,000 years from now because they are difficult and expensive to remove. If you do use concrete tanks or troughs, make SURE you get them in the right place, and have any plumbing fittings installed in them before you pour or apply the concrete.

-Advertisement-
Learn More

Here’s the best way to neutralize your concrete fish tank:

After your concrete has cured (if you don’t know what this means, you have no business building concrete tanks anyway) plug the drain in your tank, and apply the acid directly to the concrete using a brush with plastic bristles, wearing rubber gloves, protective face shield, cartridge respirator, high rubber boots, and long-sleeved protective clothing.

You need a hose with a squirt handle on it right at the top of the tank so you can hose yourself off and dilute the acid in case you accidentally get some on your clothes or skin!

The acid is known as muriatic acid, and is sold in hardware stores and building supply stores; it’s just another name for hydrochloric acid! After the acid has set on the concrete for an hour or so, rinse it off, but DON’T LET IT GO DOWN THE DRAIN!

Read also: Types of fish pond you can use in Nigeria

Leaving the acid and rinse water in the tank, now fill the tank to the top with the water (remember, you plugged your drain first?), and let it sit and soak for a couple of days. The diluted acid in the water will now have a chance to soak into and completely neutralize the highly basic new concrete.

Now drain the tank water off to a location where the acidic water cannot harm animals, plants, or people. When it is empty, rinse the inside of the tank well with a hose, letting this water go down the drain also. An ideal safe place is into an existing cesspool or septic system.

Now, check the pH of the water supply you use to fill your tank, then refill the tank to the top with new water and let sit for two days. After two days, check the tank water pH and compare to the pH reading you took of your water supply two days ago.

If the supply water pH was 7.2, and after two days in the tank it is now 8.5 or higher, you need to repeat this process with the acid wash, sit and soak AGAIN because your concrete is still bleeding off alkali (base) into the water. If your tank water pH reads between 6 and 8, you’re fine and can start your aquaponics system.

The only exception to this might be when the supply water you started with is VERY basic, i.e. 8.5 or so. In this case, if you had pH 8.5 water, and after two days in the tank it was only 8.6 or 8.7, it’s probably OK to start your system. This is an area we don’t have a good solution for yet: how do you adjust your system if your pH is high? (See System Startup and Water Quality sections for more information on pH).

Important! If you have trouble getting the pH under control in your concrete fish tank for some reason, you can do what some of our students have done: either line the tank with a vinyl liner, or smear a thick layer of household paraffin (wax) on the inside of the tank.

Both of these methods leave the inside of the tank a neutral surface that is safe for the fish. We’ve never gotten a concrete tank certified, though. To make sure your ability to get organic certification is not compromised, you should check with your proposed certification agency before committing yourself to concrete tanks.

Read also: Water quality: the key to successful fish farming

WARNING! Do NOT try to bring high pH caused by having a poorly neutralised concrete fish tank in your system down by using citric acid! Citric acid is an organic HERBICIDE, and will kill your plants roots. They all turn black, then the plants all die.

For more information and updates join our WhatsApp group HERE

Follow us on Twitter Here

We do everything possible to supply quality information for farmers day in, day out and we are committed to keep doing this. Your kind donation will help our continuous research efforts.